33-13. RIGHT FRONT FLOOR PANEL REPAIR
TM 9-2320-387-24-2
33-68
Change 1
This Task Covers:
a. Right Front Insert Panel Fabrication
f.
Metal Strip C and Insert Panel Assembly
b. Metal Strips Fabrication
g. Right Front Floor Panel and Battery Tray Drilling
c. Right Front Floor Panel Removal
h. Right Front Floor Panel and Insert Panel Drilling
d. Metal Strip A and Insert Panel Assembly
i.
Battery Tray Panel and Right Front Floor Panel Installation
e. Metal Strip B and Insert Panel Assembly
j.
Insert Panel and Right Front Floor Panel Installation
INITIAL SETUP:
Applicable Models
M1113
Tools
General mechanic’s tool set:
automotive (Appendix B, Item 1)
Riveter tool kit (Appendix B, Item 123)
Shop equipment, automotive maintenance
and repair: field maintenance, wheeled
vehicles, Post, Camp and Station, set A
(Appendix B, Item 10)
Manual References
TM 9-2320-387-24P
TM 43-0139
Materials/Parts
Ninety-four rivets (Appendix G, Item 335)
Fifteen rivets (Appendix G, Item 347.2)
Adhesive (Appendix C, Item 2.1)
Adhesive sealant (Appendix C, Item 7.1)
Front battery holdown bracket
(Appendix G, Item 9.1)
Rear battery holdown bracket
(Appendix G, Item 9.2)
Battery tray panel (Appendix G, Item 465.2)
Sheet metal (Appendix G, Item 439.1)
Equipment Condition
• Battery tray removed (para. 4-75).
• Right front floor insulation removed
(para 10-32).
Maintenance Level
General Support
NOTE
All dimensions are in inches. For Metric conversion, see chart.
1.
Cut insert panel (1) from sheet metal, and mark four reference lines (2) and directional arrow (3) on
insert panel (1).
2.
Fabricate two drain holes (4) in insert panel (1).
3.
Remove all burrs and round all sharp edges of insert panel (1).
a. Right Front Insert Panel Fabrication
