TM 9-2320-387-24-2
31-3. STEERING GEAR REPAIR (Contd)
33.
Install housing end plug O-ring seal (10) and housing end plug (9) in housing (3).
NOTE
Opening in retaining ring should be located approximately 1 in.
(25 mm) from access hole.
34.
Install retaining ring (8) in housing (3).
35.
Install side cover gasket (15) on side cover (13) by bending tabs (14) around side cover (13) edge.
36.
Install side cover (13) onto adjuster screw (16).
37.
Install four capscrews (12) on side cover (13). Tighten capscrews (12) to 40 lb-R (54 N-m).
38.
Install lash adjuster nut (11) on pitman shaft adjuster screw (16).
11
12
\T i
+L
I
0-
I
l3
01
s
14
15
8
I
0
31-17