1.
Remove three locknuts (9), washers (2), capscrews (7), washers (2), and front skid plate (6) from
front shield (8). Discard locknuts (9).
2.
Remove three locknuts (5), washers (3), capscrews (4), washers (3), and front skid plate (6) from
front bumper (1). Discard locknuts (5).
a. Front Skid Plate Removal
INITIAL SETUP:
TM 9-2320-387-24-2
10-98.4
Change 1
10-58.2. UNDERBODY PROTECTION KIT REPLACEMENT
Applicable Models
M1113
Tools
General mechanic’s tool kit: automotive
(Appendix B, Item 1)
Maintenance and repair shop equipment:
automotive (Appendix B, Item 2)
Materials/Parts
Four rubber washers (Appendix G, Item 363.1)
Forty-six locknuts (Appendix G, Item 156)
Manual References
TM 9-2320-387-24P
General Safety Instructions
• Do not perform this procedure near fire, flames,
or sparks.
• Fuel tank must be supported during removal
and installation.
Maintenance Level
Unit
This task covers:
a.
Front Skid Plate Removal
g.
Fuel Tank Shield Installation
b.
Front Shield Removal
h.
Rear Shield Installation
c.
Intermediate Shield Removal
i.
Transfer Case Shield Installation
d.
Transfer Case Shield Removal
j.
Intermediate Shield Installation
e.
Rear Shield Removal
k.
Front Shield Installation
f.
Fuel Tank Shield Removal
l.
Front Skid Plate Installation
