TM 9-2320-387-24-2
28-19. TRANSMISSION ASSEMBLY FROM SUBASSEMBLIES (Cont’d)
i. Pump Assembly Installation
1.
Install two guide pins at 12 and 5 o’clock positions on transmission case (2).
2.
Install gasket (1) over guide pins, ensuring it matches holes in transmission case (21.
3.
Using pump remover&staller, align pump assembly (4) over guide pins in transmission case (21.
CAUTION
If turbine shaft cannot be rotated as pump assembly is being
pulled into place, the overrun, fourth, forward and/or direct clutch
housings have not been properly installed. This condition must be
corrected before pump assembly is fully installed.
4.
Install pump (4) with seven capscrews (3) and tighten evenly to 18 lb& (24 N-m).
28-82
