Change 1
28-75
28-19. TRANSMISSION ASSEMBLY FROM SUBASSEMBLIES
(Cont’d)
TM 9-2320-387-24-2
6.
Lower gear unit (3) into transmission case (6). Remove gear unit remover/installer.
7.
Install center support snapring (7) against center support (1) in second snapring groove. Beveled
side of snapring (7) must be in an upward position and snapring gap at nine o’clock position.
NOTE
Perform step 8 for 1997-1998 transmissions only.
8.
Install oil cooler fitting (6.1) in transmission case (6).
4
6.1
5
6
7
8
9
10
11
3
1
1
SLIDE HAMMER
GEAR UNIT
INSTALLER/
REMOVER
LOCATION OF
SNAPRING
