TM 9-2320-387-24-2
I 27-3. BODY WIRING HARNESS REPLACEMENT (Co&d)
1
b. Installation
1.
2.
3.
4.
5.
6.
7.
8.
Install harness (5) on A-beam (2) with two clamps (14), capscrews (11, and locknuts (4).
CAUTION
Use care when installing harness. Snagging or pulling may
damage harness.
Position harness (5) in approximate mounting position. Feed forward branch of harness (5)
through hole (17).
Install left body mounts (para. 33-3).
Install grommet (16) over yellow locator tape (19) and position closeout plate (15) on grommet (16).
NOTE
Top screws connecting closeout plate may be longer than other
screws if fuel filter drain tube is routed to top of closeout plate.
Install grommet (16) and closeout plate (151 on cowl (20) with four screws (21) and locknuts (18).
Install harness ground lead 57E (8) on heater motor (7) with washer (9) and screw (10).
Connect harness lead 400D (6) to heater motor (7).
Connect harness leads 27K (12),57F (131, and 71C (11) to windshield wiper motor jumper harness
leads (3).
27-22
