TM 9-2320-387-24-l
1 6-27. COIL SPRING REPLACEMENT (Cont’d)
I
b. Installation
1.
2.
3.
4.
5.
6.
Install coil spring (1) over shock absorber (11) and onto lower control arm (121, ensuring end of coil
spring (1) fits in spring pocket of lower control arm (12).
Ensure coil spring (1) is aligned with flange of spring seat (4) and raise lower control arm (12).
Extend shock absorber (11) into spring seat (4) and install washer (31, retaining pin (2), and
locknut (5). Tighten locknut (5) to 300 lb-R (407 Nom).
NOTE
Ensure outer capscrews are installed from top down and inner
capscrews are installed from bottom up.
Install lower ball joint (7) and geared hub (61 on lower control arm (121, ensuring lower ball joint (7)
is placed below lower control arm (12). Secure with four washers (81, capscrews (91, washers (81, and
locknuts (10). Tighten locknuts (10) to 60 lb-ft (81 N-m).
Install wheel (para. 8-3).
Apply sealing compound to threads of capscrew (13). Install stabilizer bar link (15) to lower control
arm (12) with two washers (14) and capscrew (13). Tighten capscrew (13) to 70 lb-ft (95 N-m).
FOLLOW-ON TASKS: l Lower and secure hood (front springs only) (TM 9-2320-387-10).
. Install shelter (Ml113 only) (rear springs only) (para. 11-78).
6-61
