TM 9-2320-387-24-l
1 6-26. LOWER CONTROL ARM REPLACEMENT (Contd)
I
WARNlNG
Lower control arm must be supported during removal and
installation. Failure to support lower control arm may cause injury
to personnel or damage to equipment.
3.
Raise lower control arm (11) to align with geared hub (5) and lower ball joint (61, ensuring ball joint (6)
is placed below lower control arm (11).
-
_
NOTE
Ensure outer capscrews are installed from top down and inner
capscrews are installed from bottom up.
4.
Install geared hub (5) and ball joint (6) on lower control arm (11) with four washers (7), capscrews
washers (91, and locknuts (10). Tighten locknuts (10) to 60 lb-ft (81 N-m).
5.
Tighten two locknuts (3) to 260 lb-R (353 N-m).
6.
Install wheel (para. 8-3).
7.
Apply sealing compound to threads of capscrew (15). Install bar link (14) on lower control arm (1
with two washers (13) and capscrew (15). Tighten capscrew (15) to 70 lb-ft (95 N-m).
:8),
FOLLOW-ON TASK: Install shock absorber (para. 6-28).
6-59