TM20-387-24-1
I
6-16. FRONT GEARED HUB VENT LINE REPLACEMENT
1
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Tools
General mechanics tool kit:
automotive (Appendix B, Item 11
nlanual References
TM 9-2320-387-24P
Equipment Condition
Wheel removed (para. 8-3).
Maintenance Level
Unit
1 a. Removal 1
NOTE
The replacement procedure for each front geared hub vent line
is basically the same. This procedure covers the right front
geared hub vent line.
Mark clamp position before loosening to ensure clamps are
properly positioned during installation.
1.
Remove four screws (7) and clamps (3) from frame (131, front control arm (21, and geared hub (8).
2.
Loosen two clamps (6) and disconnect front vent line (4) from elbow (5) and tee fitting (1).
3.
Remove nut (121, washer (ll), screw (lo), clamp (91, and front vent line (4) from control arm (2).
b. Installation
_
1.
Install clamp (9) and front vent line (4) on control arm (2) with screw (lo), washer (111, and nut (12).
2.
Connect vent line (4) to elbow (5) and tee fitting (1) with two clamps (6).
3.
Install vent line (4) and four clamps (3) on geared hub W, control arm (21, and frame (13) with four
screws (7).
6-42
