TM 9-2320-387-24-l
6-l 5. REAR GEARED HUB VENT LINE REPLACEMENT
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
hlanual References
TM 9-2320-387-24P
Maintenance
Level
Unit
NOTE
The replacement procedure for each rear geared hub vent line is
basically the same. This procedure covers the right rear geared hub
vent line.
a. Removal
1.
Disconnect vent line (4) from geared hub fitting (3).
2.
Remove capscrew (7), clamp (61, and vent line (4) from bracket (5).
3.
Remove capscrew (81, clamp (11, and vent line (4) from control arm (2).
4.
Remove capscrew (101, clamp (91, and vent line (4) from bracket (11).
5.
Remove capscrew (151, clamp (141, and vent line (4) from frame (13).
6.
Remove vent line (4) from tee fitting (12).
Lb’Installation
1.
Install vent line (4) on tee fitting (12) and geared hub fitting (3).
2.
Install vent line (4) on frame (13) with clamp (14) and capscrew (15).
3.
Install vent line (4) on bracket (11) with clamp (9) and capscrew (10).
4.
Install vent line (4) on control arm (2) with clamp (1) and capscrew (8).
NOTE
Position clamp at a 45” angle toward the wheel before securing
with capscrew.
5.
Install vent line (4) on bracket (5) with clamp (6) and capscrew (7).
6-40
