TM 9-2320-387-24-l
4-76. SLAVE RECEPTACLE AND CABLE MAINTENANCE
This task covers:
a. Removal
b. Inspection
c. Installation
INITIAL SETUP:
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Maintenance and repair shop equipment:
automotive (Appendix B, Item 2)
Materials/Parts
Five lockwashers (Appendix G, Item 205)
Silicone compound (Appendix C, Item 75)
Manual References
TM 9-2320-387-24P
Equipment
Condition
Battery tray removed (para. 4-75).
Maintenance Level
Unit
1.
2.
3.
4.
5.
6.
7.
NOTE
Prior to removal, tag leads for installation.
Remove capscrew (8), lo&washer (9), slave negative cable (lo), and battery negative cable (11) from
shunt (1). Discard lockwasher (9).
Remove two nuts (6), lo&washers (5), washers (4), battery positive cable (7), and slave positive cable (3)
from buss bar (2). Discard lockwashers (5).
Remove four nuts (15), capscrews (17), and cover (18) from receptacle (16) and battery box (1%
Loosen compression nut (22) on backshell (21).
Remove backshell (21) from receptacle (16).
Remove capscrew (13), lockwasher (14), and slave negative cable (10) from receptacle (16). Discard
lockwasher (14).
Remove capscrew (19), lockwasher (20), and slave positive cable (3) from receptacle (16). Discard
lockwasher (20).
b. Inspection
NOTE
Cover and/or receptacle do not require replacement if dust cover
cable is broken. ‘lb replace dust cover cable, crimp a terminal ring
(NSN 5940-00-143-4794) to each end of a g-in. (22.9-cm) piece of
nylon cord (NSN 4020-00-246-0688).
1.
Inspect cover (18) for breaks and cracks. Replace if damaged.
2.
Inspect cables (3) and (10) for damage. Replace if damaged.
c. Installation
NOTE
Slave receptacle cover cord is secured under upper left capscrew.
1.
Install receptacle (16) and cover (18) on battery box (12) with four capscrews (17) and nuts (15).
2.
Install slave positive cable (3) and battery positive cable (7) on buss bar (2) with two washers (4),
lockwashers (5), and nuts (6). Tighten nuts (6) to 26 lb-R (35 Nom).
4-132
