TM 9-2320-387-24-l
4-77. WINCH POWER CABLE REPLACEMENT (Cont’d)
1 c. Rear Power Cable Removal 1
1.
Remove capscrew (8), lockwasher (7), ground lead (61, and lead 7 (5) from winch (41. Discard
lockwasher (71.
2.
Remove nut (1) and lead 6W (3) from solenoid (2).
3.
Remove nine screws (131, clamps (121, five tiedown straps (111, harness (lo), and leads 7 (51 and 6W (3)
from body (9). Discard tiedown straps (11).
4.
Removenut (181, lockwasher (191, washer (201, and lead 6W (3) from buss bar (17). Discard
lockwasher (19).
5.
Remove nut (151, lockwasher (141, and lead 7 (5) from capscrew (16). Discard lockwasher (141.
d. Rear Power Cable installation
1.
Install lead 7 (5) on capscrew (16) with lockwasher (14) and nut (15). Tighten nut (151
to 15-20 lb-R (20-27 N-m).
2.
Install lead 6W (3) on buss bar (171 with washer (201, lockwasher (191, and nut (18). Tighten nut (181
to 15-20 lb-R (20-27 N-m).
3.
Install leads 7 (5),6W (31, and harness (10) on body (9) with nine clamps (121, screws U3), and five
tiedown straps (11).
4.
Install lead 6W (3) on solenoid (2) with nut (1).
5.
Install lead 7 (5) and ground lead (6) on winch (4) with lockwasher (7) and capscrew (81.
4-136
