TM 9-2320-387-24-l
1
4-64.
DIRECTIONAL SIGNAL CONTROL CANCELLING RING REPLACEMENT
1
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Manual References
TM 9-2320-387-10
TM 9-2320-387-24P
General Safety Instructions
Failure to position cancelling pin in proper position
may cause injury to personnel or damage to
equipment.
Maintenance Level
Unit
1 a. Removal
1
Remove three screws (5) and cancelling ring (4) from steering wheel (6).
b. Installation
WARNING
Cancelling pin must be positioned 90” 2 5”. Ensure front wheels of
vehicle point straight ahead. Failure to position pin properly could
cause loss of steering, causing injury to personnel or damage to
equipment.
1. Install cancelling ring (4) on steering wheel (6) with pin (2) 90’ 2 5” from directional signal control (1).
2. Rotate steering wheel (6), ensuring pin (2) mates with directional signal control (1) and secure
cancelling ring (4) on steering wheel (6) with three screws (5).
NOTE
Gauge posts found on a new cancelling ring are there to ensure
proper installation only. Gauge posts must be removed after
installation of cancelling ring to permit proper operation of
directional signal control.
3. Cut gauge posts (3) off within l/4 in. (6 mm) of base.
FOLLOW-ON
TASK: Check directional signal Control for proper operation (TM 9-2320-387-10).
4-105
