TM 9-2320-387-24-l
I 4-5 1. BLACKOUT DRIVE LIGHT ASSEMBLY REPLACEMENT
-1
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Tools
mechanic’s tool kit:
automotive (Appendix B, Item 1)
Maintenance and repair shop equipment:
automotive (Appendix B, Item 2)
hIaterials/Parts
Lockwasher (Appendix G, Item 205)
Four nut and lockwasher assemblies
(Appendix G, Item 244)
Manual References
TM 9-2320-387-10
TM 9-2320-387-24P
Equipment
Condition
l Battery ground cables disconnected (para. 4-68).
l Hood raised and secured (TM 9-2320-387-10).
Maintenance
Level
Unit
1.
Remove nut (51, lockwasher (61, and special washer (7) from blackout drive light (1) and hood (9).
Discard lockwasher (6).
2.
Disconnect lead 198 (4) from blackout drive light (1).
3.
Remove blackout drive light (1) and coned mounting washer (3) from swivel bracket (11).
4.
Disconnect lead 92C (2) from blackout drive light (1).
5.
Remove four nut and lockwasher assemblies (81, swivel bracket (111, and plate (10) from hood (9).
Discard nut and lockwasher assemblies (8).
b. Installation
1.
Install swivel bracket (11) on outside of hood (91, and plate (10) to inside of hood (9) with four nut
and lo&washer assemblies (8). Tighten nut and lockwasher assemblies (8) to 16-30 lb-in. (2-3 Nom).
2.
Connect lead 92C (2) to blackout drive light (1).
3.
Place coned mounting washer (3) and blackout drive light (1) through hole in swivel bracket (11).
4.
Connect lead 198 (4) to blackout drive light (1).
5.
Install blackout drive light (1) on hood (91 with special washer (7), lockwasher (61, and nut (5).
4-86
