TM 9-2320-387-24-
1
4-33. GLOW PLUG CONTROLLER REPLACEMENT
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
TOOIS
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Maintenance and repair shop equipment:
automotive (Appendix B, Item 2)
Materials/Parts
Grease (Appendix C, Item 36)
Sealing compound (Appendix C, Item 61)
Manual References
TM 9-2320-387-10
TM 9-2320-387-24P
Equipment Condition
l Battery ground cables disconnected (para. 4-68).
l Hood raised and secured (TM 9-2320-387-10).
Maintenance Level
unit
NOTE
It may be necessary to clamp surge tank-to-lower radiator tube to
prevent loss of coolant.
rzEEi-j
1.
Disconnect multiple connector (2) from glow plug controller (1).
2.
Remove glow plug controller (1) from water crossover (3).
b. Instaliation
CAUTION
l Do not attempt to start engine unless controller has been
mounted in engine for a minimum of 10 minutes, or ifall glow
plugs are disconnected Damage to glow plugs may result.
l Do not over-tighten controller. Damage to water crossover may
result.
1.
Apply sealing compound to threads of glow plug controlIer (1).
2.
Install glow plug controller (11 on water crossover (3). Tighten controIler (1) to 14-20 lb-R
(19-27 Nem).
3.
Apply grease to pins (4) of glow plug controller (1).
4.
Connect multiple connector (2) to glow plug controller (1).
4-58
