TM 9-2320-387-24-l
1 8-l 8. STEERING COLUMN REPLACEMENT (Cont’d)
b. Installation
1.
2.
3.
4.
Install steering column (6) on mounting bracket (4) with two washers (181, screws (191, washers (181,
and locknuts (20). Tighten locknuts (20) finger-tight.
Install intermediate shaft (16) on steering column (6) with washer (14), capscrew (1% washer (141,
and locknut (12). Tighten locknut (12) to 40-50 lb-ft (54-68 Nom).
Connect lead 25A (21) to steering column (6).
Install two brackets (9) on steering column (6) with washer (111, capscrew (131, washer (111, and
locknut (10).
5.
Install ground wire 57C (8) on steering column (6) with screw (7) and nut and lo&washer assembly (17).
NOTE
Ensure washer and pm locking tabs are in the UP position.
6.
7.
8.
Install steering column (6) on mounting bracket (41 with pin (51, washer (31, lockwasher (21, and
locknut (1). Tighten locknut (1) finger-tight.
Position steering column (6) in upright position and tighten locknut (1) to 12-15 lb-R (16-20 Nom).
Tighten two locknuts (20) to 9-11 lb-R (12-15 Nom).
8-52
