I
TM 9-2320-387-24-l
I 8- 18. STEERING COLUMN REPLACEMENT
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Tool.5
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Maintenance and repair shop equipment:
automotive (Appendix B, Item 2)
Materials/Parts
Two locknuts (Appendix G, Item 116)
Locknut (Appendix G, Item 152)
Locknut (Appendix G, Item 141)
Locknut (Appendix G, Item 156)
Lockwasher (Appendix G, Item 205)
Nut and lockwasher assembly
(Appendix G, Item 250)
Manual References
TM 9-2320-387-24P
Equipment Condition
l Steering wheel removed (para. 8-12).
l Directional signal control removed
(para. 4-63).
Maintenance Level
Unit
1 a. Removal
1
1.
2.
3.
4.
5.
6.
Remove locknut (11, lockwasher (21, washer (31, and pin (5) from steering column (6) and mounting
bracket (4). Discard lockwasher (2) and locknut (1).
Remove nut and lo&washer assembly (171, screw (71, and ground wire 57C (8) from steering column (6).
Discard nut and lockwasher assembly (17).
Remove locknut (lo), washer (ll), capscrew (13), washer (ll), and two brackets (9) from steering
column (6). Discard locknut (10).
Disconnect lead 25A (21) from steering column (6).
NOTE
When performing step 5, temporarily install steering wheel and
turn steering column to gain access to steering column inter-
mediate shaft mounting hardware.
Remove locknut (12), washer (141, capscrew (151, washer (14), and intermediate shaft (16) from
steering column (6). Discard locknut (12).
Remove two locknuts (201, washers (18), screws (191, washers (181, and steering column (6) from
mounting bracket (4). Discard locknuts (20).
8-50
