TM 9-2320-362-14&P
3-23. STORAGE BOX REPAIR
This task covers:
a. Hinge Removal
c. Strike and Clamping Catch Removal
b. Hinge Installation
d. Strike and Clamping Catch
Installation
INITIAL SETUP:
Tools
General mechanics tool kit:
automotive (Item 1, Section III,
Appendix B)
Electric drill, (Item 2,
Section III, Appendix B)
Drill bit, 3/16-inch, (Item 2,
Section 111, Appendix B)
Riveter, blind hand (Item 2,
Section III, Appendix B)
Materials/Parts
Ten dome head rivets
P/N 1601-0619
Materials/Parts (Contd)
Two lockwashers
P/N MS35338-136
Two self-locking nuts
P/N MS21044CO6
Equipment Condition
Storage box removed (para 3-22a)
General Safety Instructions
When drilling, be sure to wear
goggles for eye protection.
1.
File small flat on rivet heads (3).
2.
Center punch flats while supporting rivet backsides.
WARNING
When drilling, be sure to wear goggles for eye
protection or injury to personnel may occur.
3.
Using 3/16-inch drill bit, drill through all rivet heads (3).
4.
Pry off rivet heads
hinge (2).
(3) and tap out rivet shanks. Remove
b. Hinge Installation
1.
Place hinge (2) in position.
2.
Rivet hinge to storage box (1) and storage box cover (4).
3-44