1.
Remove three locknuts (9), six washers (2), three capscrews (7), and front skid plate (6) from front
shield (8). Discard locknuts (9).
2.
Remove three locknuts (5), six washers (3), three capscrews (4), and front skid plate (6) from front
bumper (1). Discard locknuts (5).
a. Front Skid Plate Removal
INITIAL SETUP:
TM 9-2320-280-20-3
12-296
Change 1
12-186. UNDERBODY PROTECTION KIT REPLACEMENT
Applicable Models
M997A2, M1025A2, M1035A2, M1043A2,
M1045A2, M1097A2, M1123
Tools
General mechanic’s tool kit: automotive
(Appendix B, Item 1)
Materials/Parts
Four rubber washers (Appendix G, Item 204.1)
Forty-six locknuts (Appendix G, Item 106)
Manual References
TM 9-2320-280-10
TM 9-2320-280-24P
General Safety Instructions
• Do not perform this procedure near fire, flames
or sparks.
• Fuel tank must be supported during removal
and installation.
This task covers:
a.
Front Skid Plate Removal
g.
Fuel Tank Shield Installation
b.
Front Shield Removal
h.
Rear Shield Installation
c.
Intermediate Shield Removal
i.
Transfer Case Shield Installation
d.
Transfer Case Shield Removal
j.
Intermediate Shield Installation
e.
Rear Shield Removal
k.
Front Shield Installation
f.
Fuel Tank Shield Removal
l.
Front Skid Plate Installation
