TM 9-2320-280-20-3
12-185. SIREN AND WARNING LIGHT INSTALLATION (Contd)
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
17.
Install drivers side siren switch (15) on dash panel (14) with two lockwashers (12) and screws (13).
Route fabricated wire G (17) along tunnel (27) and connect connector (24) to lead (22) of
passengers side siren switch.
On drivers side, connect wire G (17) connector (30) to adapter connector E (28).
Connect lead (29) of drivers side siren switch (15) to adapter connector E (28).
Connect lead (31) of drivers side siren switch (15) to adapter connector B (32).
On drivers side, connect one end of fabricated wire D (33) to adapter B (32), and the other end to
adapter connector A (34).
On drivers side, connect lead B (35) of relay (36) to adapter A (34).
Route fabricated wire F" (16) along tunnel (27), and connect connector (25) to lead (23) of
passengers side siren switch (21).
On drivers side, connect wire "F" (16) to adapter connector B (32).
Locate, mark, and drill three 0.146-in. (3.7-mm) diameter holes (20) in right side engine panel (19)
and vehicle tunnel (27).
Install wires "F" (16) and G (17) on panel (19) with clamp (26) and screw (18).
Install wires F (16) and G (17) on tunnel (27) with five clamps (26) and screws (18).
Tuck exposed wires under vehicle insulation on tunnel (27).
12-289
