TM 9-2320-280-20-3
10-31. LEFT INNER COWL INSULATION PANEL REPLACEMENT (Cont’d)
I
7. Remove four screws (8) from instrument cluster (3) and dash panel (7) and pull instrument
cluster (3) away for access to speedometer cable (2).
8. Remove speedometer cable (2) and O-ring seal (4) from speedometer (1). Discard O-ring seal (4).
9. Remove grommet (6) from cowl (5) and route speedometer cable (2) through cowl (5).
10. Remove cotter pin (14), washer (13), and accelerator cable (15) from linkage (12). Discard cotter
pin (14).
11. Pull retainer (9) clear of linkage (12) and remove retainer (9) from between splash shield (10) and
frame rail (11) by pulling forward and then down.
I
b. Installation
1. Install retainer (9) by sliding up between splash shield (10) and frame rail (11) forward of cowl (5),
and then sliding back to mounting position on cowl (5).
2, Connect accelerator cable (15) to linkage (12) with washer (13) and cotter pin (14).
3. Route speedometer cable (2) through cowl (5). Install O-ring seal (4) into end of speedometer
cable (2) and connect speedometer cable (2) to speedometer (1).
4. Install instrument cluster (3) on dash panel (7) with four screws (8).
5. Install grommet (6) on speedometer cable (2) in cowl (5).
10-54
