TM 9-2320-280-20-3
10-31. LEFT INNER COWL INSULATION PANEL REPLACEMENT
This task covers:
a Removal
b. Installation
INITIAL SETUP:
Tools
Personnel Required
General mechanic’s tool kit:
One mechanic
automotive (Appendix B, Item 1)
One assistant
Materials/Parts
Manual References
Cotter pin (Appendix G, Item 17)
TM 9-2320-280-10
Four locknuts (Appendix G, Item 58)
TM 9-2320-280-24P
Three nut and lockwasher assemblies
(Appendix G, Item 144)
Equipment Condition
O-ring seal (Appendix G, Item 162)
Hood raised and secured (TM 9-2320-280-10).
1. Remove four locknuts (5), washers (3), capscrews (2), and washers (3) from harness clamp (4), brake
harness (8), retainer (1), and cowl (7). Discard locknuts (5).
2. Remove nut and lockwasher assembly (10), capscrew (12), and harness clamp (9) from body
harness (11), brake harness (8), and cowl (7). Discard nut and lockwasher assembly (10).
3. Remove nut and lockwasher assembly (15) and capscrew (13) from harness clamp (14) and
cowl (7) and disconnect body harness (11) from cowl (7). Discard nut and lockwasher assembly (15).
4. Remove upper insulation panel (6) by sliding up and out from between retainer (1) and cowl (7).
5. Remove nut and lockwasher assembly (19) and capscrew (17) from clamp (18) and cowl (7). Discard
nut and lockwasher (19).
6. Remove lower insulation panel (16) by sliding down between retainer (1) and cowl (7).
10-52
