TM 9-2320-280-20-3
11-67. TOW WIRING HARNESS REPLACEMENT
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Applicable Models
M966, M966A1, M1036, M1045, M1045A1,
M1045A2, M1046, M1046A1
Tools
General mechanic’s tool kit
automotive (Appendix B, Item 1)
Materials/Parts
Grease (Appendix C, Item 24)
TwO lockwashers (Appendix G, Item 108)
Twelve nut and lockwasher assemblies
(Appendix G, Item 146)
Manual References
TM 43-0139
TM 9-2320-280-24P
Equipment Condition
Battery ground cable disconnected (para. 4-73).
a. Removal
1.
2.
3.
4.
5.
6.
7.
11-92
NOTE
Perform steps 1 through 3 for vehicles with serial numbers 99,999 and
below and step 4 for vehicles with serial numbers 100,000 and above.
Uncoil TOW wiring harness (9) and MGS power cable (7) from cable stowage cleat (10).
Remove nut and lockwasher assembly (3) and clamp (2) from TOW wiring harness (9), MGS power
cable (7), and support assembly (4). Discard nut and lockwasher aasembly (3).
Remove two nut and lockwasher assemblies (6), screws (1), and clamps (5) from TOW wiring
harness (9), MGS power cable (7), and “B” pillar (8). Discard nut and lockwasher assemblies (6).
Uncoil TOW wiring harness (9) and MGS power cable (7) from cable stowage cleat (10).
Disconnect VPC cable (11) from connector receptacle (12).
Remove four nut and lockwasher assemblies (13), screws (16), cover (15), and connector
receptacle (12) from bracket (14). Discard nut and lockwasher assemblies (13).
Remove two nut and lockwasher assemblies (17), screws (19), and clamps (18) from TOW wiring
harness (9) and battery box (20). Discard nut and lockwasher assemblies (17).
