TM 9-2320-280-20-3
11-22. CARGO SHELL DOOR STRAP REPLACEMENT
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Applicable Models
All models except M996, M996A1, M997,
M997A1, M997A2, M998, M998A1, M1035,
M1035A1, M1035A2, M1037, M1038,
M1038A1, M1042, M1097, M1097A1, M1097A2
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Materials/Parts
.
Locknut (Appendix G, Item 65)
Two screw-assembled lockwashers
(Appendix G, Item 210)
Manual References
TM 9-2320-280-10
TM 9-2320-280-24P
Equipment Condition
Rear end of cargo shell door raised
(TM 9-2320-280-10).
a. Removal
1. Remove two screw-assembled lockwashers (3), footman loop (2), and strap (1) from cargo door (4).
Discard screw-assembled lockwashers (3).
2. Remove locknut (5), washer (6), capscrew (7), and strap (1) from left striker mounting plate (8).
Discard locknut (5).
b. Installation
NOTE
To assist closing cargo shell door, a grab loop maybe added. Refer
to appendix D, figure D-83.
1. Install strap (1) on left striker mounting plate (8) with capscrew (7), washer (6), and locknut (5).
Tighten locknut (5) to 25-30 lb-ft (34-41 N.m).
2. Install strap (1) and footman loop (2) on cargo door (4) with two screw-assembled lockwashers (3).
FOLLOW-ON TASK: Close cargo shell door (TM 9-2320-280-10).
11-40
