TM 9-2320-280-20-2
9-11. REAR BUMPER INNER MOUNTING BRACKET REPLACEMENT
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Applicable Models
Materials/Parts
M996, M996A1, M997, M997A1, M997A2,
Six locknuts (Appendix G, Item 70)
M1037, M1042, M1097, M1097A1, M1097A2
Manual References
Tools
TM 9-2320-280-24P
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
a. Removal
1. Remove two locknuts (3), washers (4), capscrews (9), and washers (4) from bracket (7) and
rear bumper (1). Discard locknuts (3).
2. Remove four locknuts (10), washers (6), capscrews (5), washers (6), spacer (8), and bracket (7)
from frame rail (2). Discard locknuts (10).
b. Installation
NOTE
1.
2.
Ensure spacer on outer side of frame rail is in position before installing
spacer and bracket.
Install spacer (8) and bracket (7) on frame rail (2) with four washers (6), capscrews (5), washers (6),
and locknuts (10). Tighten capscrews (5) to 90 lb-ft (122 N m).
Install bracket (7) on rear bumper (1) with two washers (4), capscrews (9), washers
locknuts (3). Tighten locknuts (3) to 90 lb-ft (122 N m).
(4), and
9-14
