7-24. LEFT PARKING BRAKE CABLE/MOUNTING BRACKET REPLACEMENT
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Materials/Parts
Nut and lockwasher assembly
(Appendix G, Item 148)
Four lockwashers (Appendix G, Item 110)
Cotter pin (Appendix G, Item 18)
Two clips (Appendix G, Item 13.1)
Two locknuts (Appendix G, Item 107.1)
Manual References
TM 9-2320-280-10
TM 9-2320-280-24P
Equipment Condition
• Muffler and insulator removed (all models except
M1123 and “A2” vehicles) (para. 3-48).
• Muffler and catalytic converter removed (M1123
and “A2” vehicles only) (para. 3-49).
• Wheels chocked and parking brake released
(TM 9-2320-280-10).
a. Removal
NOTE
• The following procedure applies to vehicles with serial numbers
USBL Eff. 44825 and above.
• If cables are chafing or crushed, use new cable clamp bracket.
NOTE
Perform steps 5 and 6 for vehicles with old parking brake cable
bracket. Perform steps 7 through 9 for vehicles with new parking
brake cable bracket configuration.
NOTE
Perform step 9 if clamp bracket is damaged. If not replacing bracket,
proceed to b., installation.
NOTE
Perform step 10 if replacing parking cable mounting bracket. If not
replacing bracket, proceed to b., installation.
1.
Remove cotter pin (11), washer (12), clevis pin (14), and brake clevis (13) from rear caliper lever (10).
Discard cotter pin (11).
2.
Remove brake cable clip (9) and parking brake cable sleeve (2) from rear caliper cable bracket (8).
Discard cable clip (9).
3.
Slide parking brake cable (1) through parking brake cable assembly (15). Remove parking brake cable
clip (24) and parking brake cable sleeve (2) from “C” beam (22). Disconnect parking brake cable (1) from
parking brake equalizer bar (23). Discard cable clip (24).
4.
Remove capscrew (6), washer (4), and nut and lockwasher assembly (3) from brake cable clamp (5),
mounting bracket (21) and parking brake cable assembly (15). Discard nut and lockwasher assembly (3).
5.
Remove capscrew (17), lockwasher (16), parking brake cable clamp (18), and parking brake cable
assembly (15) from bracket (19). Discard lockwasher (16).
6.
Remove two capscrews (20) and bracket (19) from support bracket (7). Discard bracket (19).
7.
Remove locknut (36), capscrew (34), washer (33), and parking brake cable clamp (32) from
bracket (28). Discard locknut (36).
8.
Remove capscrew (31), lockwasher (30), and parking brake cable clamp (29) from bracket (28).
Discard lockwasher (30).
9.
Remove locknut (26), washer (27), capscrew (35), washer (25), and clamp bracket (28) from support
bracket (7). Discard locknut (26).
10.
Remove two nuts (37), lockwashers (38), washers (39), capscrews (40), washers (39), mounting
bracket (21), and tailpipe hanger (41) from rear body mount (42). Discard lockwashers (38).
TM 9-2320-280-20-2
7-58
Change 2
