7-23. RIGHT PARKING BRAKE CABLE REPLACEMENT
This task covers:
a.
Removal
b.
Installation
INITIAL SETUP:
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Materials/Parts
Cotter pin (Appendix G, Item 18)
Two lockwashers (Appendix G, Item 87)
Two clips (Appendix G, Item 13.1)
Two locknuts (Appendix G, Item 107.1)
Manual References
TM 9-2320-280-10
TM 9-2320-280-24P
Equipment Condition
• Muffler and insulator removed (all models except
M1123 and “A2” vehicles) (para. 3-48).
• Muffler and catalytic converter removed (M1123
and “A2” vehicles only) (para. 3-49).
•Wheels chocked and parking brake released
(TM 9-2320-280-10).
a. Removal
NOTE
• The following procedure applies to vehicles with serial numbers
USBL Eff. 44825 and above.
• If cables are chafing or crushed, use new cable clamp bracket.
1.
Remove cotter pin (21), washer (20), clevis pin (18), and brake clevis (19) from rear caliper lever (22).
Discard cotter pin (21).
2.
Remove brake cable clip (1) and parking brake cable sleeve (17) from rear caliper cable bracket (2)
and remove cable assembly (4) from caliper cable bracket (2). Discard cable clip (1).
3.
Slide parking brake cable (11) through parking brake cable assembly (4). Remove parking brake
cable clip (8) from parking brake cable sleeve (7) and “C” beam (10). Disconnect parking brake
cable (4) from parking brake equalizer bar (9). Discard cable clip (8).
4.
Remove two capscrews (5), parking brake cable clamps (6), and parking brake cable assembly (4)
from body (12).
NOTE
Perform steps 5 and 6 for vehicles with old parking brake cable bracket.
Perform steps 7 through 9 for vehicles with new parking brake cable
bracket configuration.
5.
Remove capscrew (15), lockwasher (16), and parking brake cable clamp (14) from bracket (23).
Discard lockwasher (16).
6.
Remove two capscrews (13) and clamp bracket (23) from support bracket (3). Discard clamp bracket (23).
7.
Remove locknut (27), capscrew (29), washer (28), and parking brake cable clamp (30) from clamp
bracket (34). Discard locknut (27).
8.
Remove capscrew (31), lockwasher (32), and parking brake cable clamp (33) from bracket (34).
Discard lockwasher (32).
NOTE
Perform step 9 if clamp bracket is damaged. If not replacing bracket
proceed to b., installation.
9.
Remove locknut (24), washer (35), capscrew (26), washer (25), and clamp bracket (34) from support
bracket (3). Discard locknut (24).
NOTE
Ensure clamp bracket (P/N 12342965) is installed on vehicle.
1.
Install clamp bracket (34) on support bracket (3) with washer (25), capscrew (26), washer (35), and
locknut (24).
TM 9-2320-280-20-2
7-56
Change 2
b. Installation
