TM 9-2320-280-20-2
6-18. FRONT GEARED HUB VENT LINE REPLACEMENT
This task covers:
a. Right Side Removal
c. Left Side Removal
b. Right Side Installation
d. Left Side Installation
INITIAL SETUP:
Tools
Equipment Condition
General mechanic’s tool kit:
Wheel removed (para. 8-3).
automotive (Appendix B, Item 1)
Manual References
TM 9-2320-280-24P
a. Right Side Removal
NOTE
Mark clamp position before loosening to ensure clamps are properly
positioned during installation.
1. Loosen four screws (7) and clamps (3) from front control arm (2) and geared hub (8).
2. Remove two hose clamps (6) and front vent line hose (4) from elbow (5) and tee fitting (1).
b. Right Side Installation
NOTE
Step 1 is necessary to prevent vent line damage. If new clamp has
been previously installed, perform steps 3 through 5.
1. Locate, mark, and drill 0.266 in. (6.76 mm) diameter hole (9) in front control arm (2).
6-44
