TM 9-2320-280-20-2
6-17. REAR GEARED HUB VENT LINE REPLACEMENT
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Tools
Manual References
General mechanic’s tool kit:
TM 9-2320-280-24P
automotive (Appendix B, Item 1)
NOTE
Rear geared hub vent line replacement procedures are basically
the same. This procedure covers the right rear geared hub
vent line.
1. Disconnect vent line (4) from geared hub fitting (3).
2. Remove capscrew (7), clamp (6), and vent line (4) from bracket (5).
3. Remove capscrew (8), clamp (1), and vent line (4) from control arm (2).
4. Remove capscrew (10), clamp (9), and vent line (4) from bracket (11).
5. Remove capscrew (15), clamp (14), and vent line (4) from frame (13).
6. Remove vent line (4) from tee fitting (12).
b. Installation
1. Install vent line (4) to tee fitting (12) and geared hub fitting (3).
2. Install vent line (4) to frame (13) with clamp (14) and capscrew (15).
3. Install vent line (4) to bracket (11) with clamp (9) and capscrew (10).
4. Install vent line (4) to control arm (2) with clamp (1) and capscrew (8).
NOTE
Position clamp at a 45° angle toward the wheel before securing
with capscrew.
5. Install vent line (4) to bracket (5) with clamp (6) and capscrew (7).
6-42
