TM 9-2320-280-20-2
5-9. SHIFT CONTROLS HOUSING ASSEMBLY (SF-5583581) REPAIR
This task covers:
a. Disassembly
c. Inspection
b. Cleaning
d. Assembly
INITIAL SETUP:
Applicable Models
Materials/Parts (Cont’d)
All vehicles except M997A2, M1025A2,
Three locknuts (Appendix G, Item 85)
M1035A2, M1043A2, M1045A2, M1097A2
Four lockwashers (Appendix G, Item 110)
Sealing compound (Appendix C, Item 44
Tools
General mechanic’s tool kit:
Manual References
automotive (Appendix B, Item 1)
TM 9-2320-280-24P
Materials/Parts
Equipment Condition
Spring pin (Appendix G, Item 234)
Shift controls housing assembly disassembled
Retaining ring (Appendix G, Item 172)
(para. 5-8).
a. Diassembly
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
Remove retaining ring (12) from shift control shaft (23) and shift controls housing (7). Discard retaining ring (12).
Remove spring pin (16) from spring retaining collar (15) and shaft control (23). Discard spring pin (16).
Remove shift control shaft (23), spring retaining collar (15), and shift control compression spring (17)
from shift controls housing (7).
Remove transfer shift lever (10) by sliding down and out from shift controls housing (7).
Remove two nylon flanged bearings (13) from transfer shift lever arm (14).
Remove spring pin (11) from transfer shift lever arm (14) and remove transfer shift lever (10) from
transfer shift lever arm (14).
Remove transmission shift tube (28) by sliding down and out from shift controls housing (7).
NOTE
Note position of transmission shift lever for installation.
Remove four nuts (26), lockwashers (27), capscrews (18), washers (19), transmission shift tube (28),
shift lever latch spring (24), and transmission shift lever (20) from bracket and shaft assembly (21).
Discard lockwashers (27).
Remove nylon flanged bearing (22) from bracket and shaft assembly (21).
Remove shift lever latch rod (25) by sliding out from transmission shift tube (28).
Remove three locknuts (9), washers (8), capscrews (2), washers (3), and bezel (1) from wiper (5) and
shift controls housing (7). Discard three locknuts (9).
Remove three washers (4) and wiper (5) from shift controls housing (7).
Remove bearing (6) from shift controls housing (7).
Clean all shift control housing assembly parts in accordance with para. 2-10.
5-22
