TM 9-2320-280-20-2
4-102. INTERIOR LIGHTING HARNESS ASSEMBLY REPLACEMENT (M996, M996A1) (Cont’d)
24. Remove four screws (7) from cover (6) and body (15).
25. Remove nut and lockwasher assembly (3), screw (10), clamp (11), and cover (6) from light
harness (14). Discard nut and lockwasher assembly (3).
26. Remove grommet (9) from cover (8).
27. Disconnect two harness leads (5) from light leads (4).
28. Remove ten screws (13) from cover (8) and body (15). Lower cover (8) to allow access to harness (1).
29. Disconnect six harness leads (2) from light harness leads (12). Remove harness cover (8).
CAUTION
Use care when removing harness. Failure to do so will cause
damage to harness.
30. Remove harness (1) from body (15).
CAUTION
1.
2.
3.
4.
5.
6.
7.
4-226
Use care when routing harness. Failure to do so will cause
damage to harness.
Route harness (1) through vehicle in approximate mounting location.
Position harness cover (8) over harness (1) and connect six harness leads (2) to light harness
leads (12). Install cover (8) on body (15) with ten screws (13).
Connect two harness leads (5) to light leads (4).
Install grommet (9) on cover (8).
Install clamp (11) and light harness (14) on cover (6) with screw (10) and nut and lockwasher
assembly (3).
Install cover (6) on body (15) with four screws (7).
Install six clamps (16) and harness (1) on body (18) with six screws (17).
