TM 9-2320-280-20-2
4-90. ELECTRICAL OUTLET/BRACKET MAINTENANCE
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Applicable Models
Equipment Condition
M996, M996A1, M997, M997A1, M997A2
Battery ground cable disconnected
(para. 4-73).
Tools
Rear doors opened (TM 9-2320-280-10).
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Manual References
TM 9-2320-280-10
TM 9-2320-280-24P
NOTE
Prior to removal, tag leads for installation.
a. Removal
1. Slide rubber boot (1) away from outlet (4).
2. Remove two screws (3) and pull outlet (4) away from bracket (2).
3. Loosen screw (8) and move shield (9) away from screws (7).
4. Remove two screws (7), disconnect harness leads 714B (11) and 790A
NOTE
Perform step 5 only if removing bracket.
5. Remove three screws (6) and bracket (2) from body (5).
b. Installation
1. Install bracket (2) on body (5) with three screws (6).
(10) and remove outlet (4).
2. Connect leads 714B (11) and 790A (10) to outlet (4) with two screws (7).
3. Position shield (9) over screws (7) and tighten screw (8).
4. Install outlet (4) on bracket (2) with two screws (3).
5. Slide boot (1) over back of outlet (4).
4-164
