TM 9-2320-280-20-2
4-73. BATTERY CABLE MAINTENANCE (Cont’d)
NOTE
Perform steps 3 through 5 for M997A2, M1025A2, M1035A2,
M1043A2, M1045A2, and M1097A2 vehicles only. Perform steps 6
and 7 for all other vehicles.
3. Loosen two nuts (12) and remove terminal clamps (17) from terminals (11).
4. Remove nut (18), capscrew (14), cable (13), leads (15) and cable (16) from terminal clamp (17).
5. Remove nut (18) and screw (14) from cable (16) and terminal clamps (17).
6. Loosen two nuts (12) and remove terminal clamps (17) from terminals (11).
7. Remove two screws (14), nuts (18), and cable (16) from terminal clamps (17).
8. Remove cable (16) from terminal clamps (17) and battery terminal boot (20).
g. Interconnecting Cable Installation
NOTE
All vehicles except M997A2, M1025A2, M1035A2, M1043A2,
M1045A2, and M1097A2 vehicles have two caps and boots.
1. Push battery terminal boot (20) onto cable (16) and install cable (16) on terminal clamp (17) with
screw (14) and nut (18).
2. Apply a 1/16 in. (1.6mm) bead of lubricating oil to battery post pads (10). DO not allow oil to coat
terminal posts (11).
NOTE
Perform steps 3 and 4 for M997A2, M1025A2, M1035A2,
M1043A2, M1045A2, and M1097A2 vehicles only. Perform steps 5
and 6 for all other vehicles.
3. Install cable (16), leads (15), and cable (13) to terminal clamp (17) with screw (14) and nut (18).
4. Install two terminal clamps (17) on terminals (11) and tighten nuts (12).
5. Install cable (16) on terminal clamp (17) with capscrew (14) and nut (18).
6. Install two terminal clamps (17) on terminal posts (11) and tighten nuts (12).
7. Fill battery terminal boot (20) with lubricating oil.
8. Install cap (19) to battery terminal boot (20).
4-119
