TM 9-2320-280-20-2
Section II. STARTER AND STARTING CONTROL SYSTEM MAINTENANCE
4-6. STARTER AND STARTING CONTROL SYSTEM MAINTENANCE TASK
SUMMARY
TASK
PROCEDURES
PAGE
PARA.
NO.
4-7.
Rotary Switch Replacement
4-14
4-8.
Starter Replacement
4-16
4-9.
Circuit Breaker Replacement
4-20
4-7. ROTARY SWITCH REPLACEMENT
This Task Covers:
a. Removal
b. Installation
INITIAL SETUP:
Tools
Manual References
General mechanic’s tool kit:
TM 9-2320-280-10
automotive (Appendix B, Item 1)
TM 9-2320-280-24P
Materials/Parts
Equipment Condition
Two lockwashers (Appendix G, Item 111)
Battery ground cable disconnected (para. 4-73).
NOTE
Prior to removal, tag leads and note position of lever for installation.
a. Removal
1. Remove screw (8), lockwasher (7) and switch lever (6) from switch shaft (9). Discard lockwasher (7).
2. Remove nut (5) and lockwasher (4) from switch (2) and instrument panel (3). Discard lockwasher (4).
3. Push switch (2) out of hole in panel (3).
4. Disconnect three electrical leads 11A (1), 14A (10), and 29A (11) from switch (2) and remove switch (2).
b. Installation
1. Connect three electrical leads 11A (1), 14A (10), and 29A (11) on switch (2).
2. Install switch (2) into hole in panel (3).
3. Install lockwasher (4) and nut (5) on switch (2).
4. Place switch lever (6) on switch shaft (9) to indicate “ENGINE STOP” position.
5. Secure lever (6) on switch shaft (9) with lockwasher (7) and screw (8).
4-14
