TM 9-2330-392-14&P
4-22
Change 2
4-16
COMPOSITE STOPLIGHT-TAILLIGHT MAINTENANCE (Con't).
b.
LAMP ASSEMBLY REMOVAL
NOTE
Tag wires for installation if marker bands are missing or illegible.
1.
Cut and remove wire ties from wiring harness shield and remove split wiring harness shield. Do not discard
shield.
2.
Disconnect four leads (11) from body wiring harness (12).
3.
Remove two capscrews (7) securing plate (8), ground strap (13), and composite light (10) to composite light
housing (9).
4.
Remove composite light assembly (10) by feeding wires, one at a time, through composite light housing (9).
c.
LAMP ASSEMBLY INSTALLATION
1.
Install composite light assembly (10) in housing (9) by feeding wires, one at a time, through housing (9).
CAUTION
Housing is plastic material. Do not overtighten capscrews.
2.
Install one capscrew (7) through ground strap (13), plate (8), and housing (9) into composite light assembly (10).
Install other capscrew through plate (8) and housing (9) into composite light (10).
3.
Tighten two capscrews (7).
4.
Connect leads (11) to body wiring harness (12).
5.
Install wiring harness shield to wiring harness and install tie wraps.
FOLLOW-ON TASKS:
•
Connect intervehicular cable to towing vehicle (para 2-10).
•
Check operation of light (TM 9-2320-280-10).
