TM 9-2320-387-24-2
25-94
Change 1
25-35. A/C WIRING HARNESS AND CABLE MAINTENANCE
This task covers:
a. Removal
c.
Installation
b. Inspection
INITIAL SETUP:
Applicable Models
M1114
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Automotive maintenance and repair: field
maintenance, basic (Appendix B, Item 6)
Materials/Parts
Sealing compound (Appendix C, Item 63)
Silicone rubber (Appendix C, Item 12)
Four lockwashers (Appendix G, Item 199)
Tiedown straps (as required)
(Appendix G, Item 461.1)
Manual References
TM 9-2320-387-24P
Equipment Condition
• A/C front air distribution duct removed
(para. 11-81).
• Heater/evaporator assembly cover removed
(para. 25-21).
• Access hole cover plate removed (para. 25-36).
• Condenser fan access panel removed
(para. 11-86).
• Air horn-to-air cleaner elbow removed
(para. 3-15).
• A/C coolant line covers removed (para. 25-32).
Maintenance Level
Direct support
NOTE
Prior to removal tag leads for assembly
1.
Remove four capscrews (7) and washers (6) securing A/C condenser (4) to left rear wheelwell (5).
2.
Remove A/C condenser (4) from left rear wheelwell (5). Do not disconnect coolant lines.
3.
Remove tiedown straps (8), as required, from A/C wiring harness (3) and fan grille (9).
4.
Disconnect two A/C wiring harness connectors (2) from A/C condenser fan connectors (1).
5.
Remove two A/C wiring harness connectors (2) from A/C wiring harness (3).
6.
Route A/C wiring harness (3) down through grommet (11) at left rear wheelwell (5) and forward
through grommet (12) at left rear wheelhouse (13).
7.
Disconnect A/C wiring harness connector (14) from rear A/C evaporator connector (10).
8.
Remove tiedown straps (15), as required, from A/C wiring harness (3) along left side tunnel (16).
a. Removal
2
3
4
5
6
7
1
8
9
3
