TM 9-2320-387-24-2
25-36.8
Change 1
25-13.2. 10,500 LB HYDRAULIC WINCH REPAIR (Cont'd)
Clean all winch components in accordance with para. 2-14.
NOTE
For general inspection instructions, refer to para. 2-15.
1.
Inspect motor (1), splines (3), and mating surface (2) for damage or wear. Replace if damaged or
worn.
2.
Inspect valve and solenoid assembly (4) and restrictor (5), O-ring (6), and restrictor washer (7) for
damage or wear. Replace valve and solenoid assembly (4) if any parts are damaged or worn.
3.
Inspect motor end/drum support (13) and drum bushing (12) for damage or wear. Replace any
damaged or worn parts.
4.
Inspect drive shaft thrust washer (8), splines (9), and machine surfaces (11) of drive shaft
assembly (10) for damage or wear. Replace any damaged or worn parts.
5.
Inspect drum assembly (14) for damage to roller bearing (16), planetary gear shafts (17), and
tube (15). Replace drum assembly (14) if any parts are damaged or worn.
6.
Inspect shaft plunger plate (19), three planetary gears (24) and bearings (23), planetary springs
(18), planetary washers (22), snaprings (20), and snaprings (21) for damage or wear. Replace drum
assembly (14) if any parts are damaged or worn.
c. Inspection
b. Cleaning
2
3
1
