TM 9-2320-387-24-2
15-27. ENGINE PREPARATION
This task covers:
a. Disassembly
INITIAL SETUP:
b. Assembly
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Special Tools
Hex-head driver, &mm (Appendix B, Item 145)
Torque adapter, g/X-in. (Appendix B, Item 133)
Crowfoot, 9/16-in. (Appendix B, Item 139)
Engine stand (Appendix B, Item 28)
Materials/Parts
Five lockwashers (Appendix G, Item 239)
O-ring seal (Appendix G, Item 279)
Six lo&washers (Appendix G, Item 205)
Two lockwashers (Appendix G, Item 238)
Six lockwashers (Appendix G, Item 217)
Nut and lockwasher assembly
(Appendix G, Item 245)
Antiseize compound (Appendix C, Item 16)
Rl’V sealant (Appendix C, Item 10)
Materials/Parts
(Cont’d)
Sealing compound (Appendix C, Item 65)
Sealing
compound,
thread-locking
(Appendix
C, Item 66)
Manual References
TM 9-2320-387-24P
Equipment Condition
Engine removed (para. 15-26).
General Safetv Instructions
l Direct personnel to stand clear during hoisting
operation.
l Starter must be supported during removal and
installation.
l Power steering pump must be supported during
removal and installation.
Maintenance Level
Direct support
WARNING
Direct personnel to stand clear during hoisting operation. Failure
to do this may cause injury to personnel.
a. Disassembly
1.
Place engine on stand and disconnect hoist.
NOTE
Have drainage container ready to catch oil.
2.
Remove drainplug (5) and gasket (6) from oil pan (4). Allow oil to drain completely.
3.
Install gasket (6) and drainplug (5) on oil pan (4). Tighten drainplug (5) to 20 lb-R (27 N-m).
4.
Remove two capscrews (3) and sling bracket (7) from left cylinder head (8).
’
5.
Remove pin (2) from sling bracket (7) and engine lifting sling (1).
6.
Remove two capscrews (9) and engine lifting sling (1) from right cylinder head (10).
I 5-78
