TM 9-2320-387-24-2
12-68.14
Change 1
12-36.4. 10,500 LB REAR HYDRAULIC WINCH HOSE REPLACEMENT (Cont'd)
NOTE
• Use tape on one hose for ease of installation and identification
from rear winch to valve assembly port.
• When positioning hoses on vehicle, place ends with heat shield
closest to fittings at rear of vehicle.
1.
Starting from left rear of vehicle (14), route two hydraulic hose assemblies (1) and (2) over rear
crossmember (13), over differential support (12), and over muffler (11).
2.
Route two hydraulic hose assemblies (1) and (2) between speedometer drive (15) and transfer
case (16). Continue along right side of transmission shift linkage (10), next to transfer case cooler
lines (9), and towards front of vehicle.
3.
Route two hydraulic hose assemblies (1) and (2) along left inner cowl (6), two hydraulic hoses (7),
and between body wiring harness (8) to port 2 adapter (3) and port 4 adapter (5) on valve
assembly (4).
4.
Connect hydraulic hose assembly (1) to port 2 adapter (3) on valve assembly (4).
5.
Connect hydraulic hose assembly (2) to port 4 adapter (5) on valve assembly (4).
b. Installation
