TM 9-2320-387-24-2
I 12-36.
REAR WINCH
CLUTCH CABLE REPLACEMENT
1
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Applicable Models
Ml114
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Manual References
TM 9-2320-387-24P
Maintenance Level
Unit
hlaterialearts
Locknut (Appendix G, Item 160)
1 a. Removal
]
1.
Remove locknut (61, washer (7), rod end (81, two washers (91, and capscrew (11) from lever (10).
Discard locknut (6).
2.
Loosen nut (5) and remove rod end (8) and nut (5) from cable (4).
3.
Loosen nut (2) and remove handle (1) and nut (2) from cable (4).
4.
Remove two clips (3) and cable (4) from bracket (12).
b. Installation
1.
Install cable (4) on bracket (12) with two clips (3).
2.
Install nut (2) and handle (1) on cable (4). Tighten nut (2).
3.
Install nut (5) and rod end 03) on cable (4) and adjust rod end (8) and nut (5) as required to allow full
clutch operation.
4.
Tighten nut (5).
5.
Install capscrew (111, two washers (9), and rod end (8) on lever (10) with washer (7) and locknut (6).
12-68
