TM 9-2320-387-24-2
12-54.4
Change 1
12-27.1. 10,500 LB HYDRAULIC WINCH AND BRACKETS REPLACEMENT (Cont'd)
WARNING
Winch and bumper must be supported with a floor jack during
winch replacement. Failure to support winch may result in injury
to personnel or damage to equipment.
8.
Remove four locknuts (14), washers (10), capscrews (11), washers (10), and two tow brackets (9)
from winch and bumper assembly (8) and left and right bracket assemblies (5). Discard
locknuts (14).
9.
Remove two locknuts (12), washers (13), and winch and bumper assembly (8) from left and right
lower control arm screws (1). Discard locknuts (12).
NOTE
• Brackets may not require replacement. Replace brackets only
when damaged.
• The left and right side brackets are removed the same. This
procedure covers the left side.
1.
Remove three locknuts (3), washers (2), capscrews (15), and washers (2) from left hand bracket
assembly (5) and frame (16). Discard locknuts (3).
2.
Remove capscrew (7), washer (6), and left hand bracket assembly (5) from grille extension (4).
1.
Install left hand bracket assembly (5) on grille extension (4) with washer (6) and capscrew (7).
Finger tighten capscrew (7).
2.
Install left hand bracket assembly (5) on frame rail (16) with three washers (2), capscrews (15),
washers (2), and locknuts (3). Tighten locknuts (3) to 225 lb-ft (303 N•m).
1.
Install winch and bumper assembly (8) on left and right lower control arm screws (1) with two
washers (13) and locknuts (12). Finger tighten locknuts (12).
2.
Secure winch and bumper assembly (8) and two tow brackets (9) on left and right bracket
assemblies (5) with four washers (10), capscrews (11), washers (10), and locknuts (14).
3.
Tighten locknuts (12) to 260 lb-ft (353 N•m).
d. Winch Installation
c. Brackets Installation
b. Brackets Removal
