12-18. TERMINAL BOARD REPLACEMENT
This task covers:
a. Removal
b. Installation
NOTE
Tag all leads for installation.
1.
Loosen two terminal lugs (2) and remove cover (1) from terminal board (10).
2.
Remove nut (15), lockwasher (14), washer (13), and three leads (12) from positive post (9) of
terminal board (10). Discard lockwasher (14).
3.
Remove nut (3), lockwasher (4), washer (5), and three leads (6) from negative post (8) of terminal
board (10). Discard lockwasher (4).
4.
Remove three screws (11) and terminal board (10) from support bracket (7).
INITIAL SETUP:
Applicable Models
M1114
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Materials/Parts
Sealing compound (Appendix C, Item 70)
Manual References
TM 9-2320-387-24P
Equipment Condition
Battery ground cables disconnected (para. 4-68).
Maintenance Level
Unit
b. Installation
NOTE
Apply sealant compound to negative and positive posts on
terminal board.
1.
Install terminal board (10) on support bracket (7) with three screws (11).
2.
Install three leads (6) on negative post (8) of terminal board (10) with washer (5), lockwasher (4),
and nut (3).
3.
Install three leads (12) on positive post (9) of terminal board (10) with washer (13), lockwasher (14),
and nut (15).
4.
Install cover (1) on terminal board (10) and tighten two terminal lugs (2).
TM 9-2320-387-24-2
12-32
Change 1
a. Removal
