11-74
Change 1
NOTE
Note location of screws, nuts, spacers, and brackets for installation.
1.
Remove four capscrews (12), washers (11.1), and shim (10) from from right front underbody armor (11)
and bracket (8).
2.
Remove six socket-head screws (17) and three plates (18) from right front underbody armor (11) and
three brackets (24).
3.
Remove twelve capscrews (2) from right front underbody armor (11) and footwell armor (3).
4.
Remove fourteen locknuts (6) and capscrews (16) from right front underbody armor (11). Discard
locknuts (6).
5.
Remove twelve locknuts (4), spacers (5), and capscrews (15) from right front underbody armor (11)
and body (7). Discard locknuts (4).
6.
Remove seven screws (19), washers (20), and spacers (21) from right front underbody armor (11) and
body (7).
NOTE
Support upper cowl liner when removing right front underbody
armor.
6.1
Remove five locknuts (9) and capscrews (5.1) from upper cowl liner (5.2), body (7), and right front
underbody armor (11). Discard locknuts (9).
7.
Remove eight socket-head screws (22) and right front underbody armor (11) from rocker panel (27).
NOTE
• Perform step 8 if removing air cleaner mounting brackets.
• Perform step 9 if removing brackets and clamps.
.WARNING.
Right front underbody armor plate is extremely heavy and must be
supported during removal and installation. Failure to do so may
result in injury to personnel or damage to equipment.
NOTE
If new right front underbody armor is being installed, perform para. 11-38.1.
11-38. RIGHT FRONT UNDERBODY ARMOR MAINTENANCE
This task covers:
a. Removal
c.
Installation
b. Inspection
INITIAL SETUP:
Applicable Models
M1114
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Maintenance and repair shop equipment:
automotive (Appendix B, Item 2)
Personnel Required
Thirty-one locknuts (Appendix G, Item 169)
Six locknuts (Appendix G, Item 170)
Sealing compound (Appendix C, Item 72.1)
Adhesive (Appendix C, Item 2.1)
Personnel Required
One mechanic
One assistant
Manual References
TM 9-2320-387-10
TM 9-2320-387-24P
Equipment Condition
• Air cleaner removed (para. 3-12).
• Right side rocker panel armor removed (para. 11-35).
• Right front cowl insulation removed (para. 10-32).
• Heater/evaporator removed (para. 25-21).
General Safety Instructions
Right front underbody armor plate is extremely
heavy and must be supported during removal and
installation.
Maintenance Level
Unit
TM 9-2320-387-24-2
a. Removal
