TM 9-2320-387-24-2
I
1 O-77.
DEFROST CONTROL REPLACEMENT
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Applicable Models
Ml113
Tools
Manual References
TM 9-2320-387-10
TM 9-2320-387-24P
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Materials/Parts
Equipment Condition
l Hood raised and secured (TM 9-2320-387-10).
l Engine access cover removed (para. 10-22).
Pushnut (Appendix G, Item 313)
Maintenance Level
Lockwasher (Appendix G, Item 215)
Unit
I a. Removal I
1.
Remove four capscrews (2) from instrument cluster (5) and instrument panel (3).
2.
Pull instrument cluster (5) away from panel (3).
3.
Remove screw (15) from clip (10) and diverter box (12).
4.
Remove pushnut (13) and disconnect defroster cable core (11) from baMe pin (14). Discard
pushnut (13).
5.
Pull control cable (6) through firewall (9) and three clamps (7) on A-beam (8) and firewall (9).
6.
Remove nut (4) from
panel (3).
threaded shaft (1) and instrument panel (3) and pull control cable (6) through
b. Installation
1.
Feed control cable (6) through instrument panel (3) and install threaded shaft (1) on panel (3) with
nut (4).
2.
Route control cable (6) through three clamps (7) on A-beam (8) and firewall (9).
3.
Connect defroster cable core (11) on baffle pin (14) and install pushnut (13).
NOTE
Control wire and knob must be pushed in, and baffle pin must be
in the upward position before securing control cable to
diverter box.
4.
Install clip (10) on diverter box (12) with screw (15).
5.
Install instrument cluster (5) on panel (3) with four capscrews (2).
. .
lo-132
