Change 1
D-84.3
TM 9-2320-387-24-2
Section II. ILLUSTRATED MANUFACTURING INSTRUCTIONS (Cont‘d)
Figure D-104. Open End Wrench.
INSTRUCTIONS:
1. Using NSN 9515-00-814-7316 metal strip, cut one piece 0.188-in. (4.775-mm) thick to make handle (2)
as shown.
2. Using NSN 9515-00-569-2044 metal strap, cut two pieces 0.125-in. (3.175-mm) thick to make two
jaws (1) as shown.
3. Weld two jaws (1) to handle (2) as shown.
4. Remove all burrs and sharp edges.
10.000 in. (254.000 mm)
0.188 in.
(4.775 mm)
1.250 in.
(31.750 mm)
1.250 in.
(31.750 mm)
1.250 in.
(31.750 mm)
0.130 in.
(3.302 mm)
0.130 in.
(3.302 mm)
4 PL
0.125 in.
(3.175 mm)
0.125 in.
(3.175 mm)
0.250 in.
(6.350 mm)
0.250 in.
(6.350 mm)
0.250 in.
(6.350 mm)
0.250 in.
(6.350 mm)
0.250 in.
(6.350 mm)
2.375 in.
(60.325 mm)
2.875 in.
(73.025 mm)
2 PL
0.120 in.
(3.048 mm)
0.120 in.
(3.048 mm)
45° 2 PL
0.120 in.
(3.048 mm)
R 2 PL
2
1
SHEET
CUT TO SIZE
MANUFACTURED
PART NUMBER
(INCHES)
FROM NSN
N/A
AS SHOWN
9515-00-596-2044
9515-00-814-7316
MATERIAL BLOCK
STOCK SIZE
DESCRIPTION
SPECIFICATION
0.125-in. (3.175 mm) THICK
STRIP, METAL
ASTM A569
0.188-in. (4.775 mm) THICK
