33-14. RIGHT REAR FLOOR PANEL REPAIR (Cont’d)
TM 9-2320-387-24-2
Change 1
33-101
1.
Position metal strip D (6), with arrow facing up and right, on insert panel (2). Align reference lines (4)
and insert panel edges (7).
2.
Using metal strip D (6) as a template, locate, mark, and drill nine 0.187-in. (4.75-mm) diameter
holes through insert panel (2). Remove metal strip D (6).
3.
Apply approximately 0.125-in. (3.175-mm) thickness of adhesive sealant to shaded surface of insert
panel (2) and metal strip D (6).
4.
Position metal strip D (6) on insert panel (2) and install with nine rivets (8).
5.
Remove any adhesive residue and clean edges of metal strip D (6) and insert panel (2).
i. Metal Strip D and Insert Panel Assembly
DRILL NINE 0.187-IN. (4.75-MM) DIAMETER HOLES
