TM 9-2320-387-24-2
10-58.2. UNDERBODY PROTECTION KIT REPLACEMENT (Cont’d)
10-98.10
Change 1
.WARNING.
• Fuel tank must be supported during removal. Failure to do so
may cause damage to fuel tank or injury to personnel.
• Diesel fuel is highly flammable. Do not perform this task near
fire, flames, or sparks. Severe injury or death may result.
1.
Drain fuel tank (1) (refer to para. 3-25).
2.
Remove two locknuts (6), washers (2), capscrews (3), washers (2), and support straps (5) from upper
straps (4). Discard locknuts (6).
3.
Swing support straps (5) down and remove fuel tank shield (7).
.WARNING.
• Fuel tank must be supported during installation. Failure to do
so may cause damage to fuel tank or injury to personnel.
• Diesel fuel is highly flammable. Do not perform this task near
fire, flames, or sparks. Severe injury or death may result.
1.
Position fuel tank shield (7) on fuel tank (1) and raise support straps (5).
NOTE
Maintain 0.50-in. (13-mm) clearance between upper and lower
straps when tightening locknuts.
2.
Install support straps (5) on upper straps (4) with two washers (2), capscrews (3), washers (2), and
locknuts (6). Tighten locknuts (6) to 37 lb-ft (50 N•m).
3.
Fill fuel tank (1) (refer to TM 9-2320-387-10).
g. Fuel Tank Shield Installation
f. Fuel Tank Shield Removal
