TM 9-2320-387-24-2
1 30-3. DIFFERENTIAL REPAIR (cont’d)
I
3.
Remove locknut (3), seal washer (71, output flange (61, and output shaft seal (51 from output shaft (41.
Discard seal washer (71, output sh& seal (51, and locknut (31.
4.
Repeat steps 1 through 3 for opposite side.
5.
Install two axle holding furture adapters on housing (1) with four capscrews (101. Place housing (11
in holding stand.
6.
Position housing (1) so differential cover (8) faces up. Remove twelve capscrews (91 and cover (8)
from housing ( 1).
AxlElKxDlNG
I
FIXTURE
ADAm
AXLE HOLDING
FIXTURE ADAPTER
30-3
