28-2
Change 1
28-3. TRANSMISSION DISASSEMBLY INTO SUBASSEMBLIES
INITIAL SETUP:
Tools
General mechanics tool kit:
automotive (Appendix B, Item 1)
Dial indicator (Appendix B, Item 113)
Special Tools
Transmission holding fixture
(Appendix B, Item 57)
Transmission holding fixture base
(Appendix B, Item 58)
Holding tool adapter (Appendix B, Item 62)
Slide hammer adapter (Appendix B, Item 59)
Oil pump remover/installer tool
(Appendix B, Item 64)
Torx drive socket (Appendix B, Item 36)
Gear unit installer/remover
(Appendix B, Item 65)
Personnel Required
One mechanic
One assistant
Manual References
TM 9-2320-387-24P
Equipment Condition
Transmission prepared for disassembly
(para. 19-5).
General Safety Instructions
Torque converter must be supported during
removal.
Maintenance Level
General support
TM 9-2320-387-24-2
This task covers:
a.
Torque Converter Removal
i.
Front End Play Check (Measured)
b.
Holding Fixture Installation
j.
Rear Unit End Play Check (Measured)
c.
Speed Sensors Removal
k.
Pump Assembly Removal
d.
Oil Pan and Filter Assembly Removal
l.
Turbine Shaft and Overdrive Carrier Assembly
e.
Control Valve Assembly Removal (1995-1996)
Removal
e.1. Control Valve Assembly Removal (1997-1998)
m.
Forward Clutch Assembly Removal
f.
Front Servo Removal
n.
Direct Clutch Assembly Removal
g.
Rear Servo Removal
o.
Intermediate Clutch Assembly Removal
h.
Parking Lock Pawl and Actuator Assembly
p.
Gear Unit Assembly and Rear Band Removal
Removal
q.
Center Support Assembly Removal
a. Torque Converter Removal
WARNING
Torque converter must be supported during removal and
installation. Failure to do this may cause injury to personnel or
damage to equipment.
NOTE
Be certain torque converter turns freely. Record any abnormal
looseness or noises.
Remove torque converter (2) from transmission (1).
1
2
