7-4. SERVICE BRAKE CALIPER MAINTENANCE
TM 9-2320-387-24-1
7-10
Change 1
This task covers:
a. Removal
c.
Installation
b. Cleaning and Inspection
INITIAL SETUP:
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Maintenance and repair shop equipment:
automotive (Appendix B, Item 2)
C-clamp (Appendix B, Item 153)
Special Tools
Hex-head driver, 7-mm
(Appendix B, Item 151)
Crowfoot, 14-mm (Appendix B, Item 141)
Materials/Parts
Copper washer (Appendix G, Item 24)
Grease (Appendix C, Item 34)
Sealing compound (Appendix C, Item 63)
Manual References
TM 9-2320-387-24P
Equipment Condition
Brake pads removed (para. 7-3).
General Safety Instructions
Ensure brake pads are installed with linings
facing rotor.
Maintenance Level
Unit
a. Removal
CAUTION
Cover or plug all open lines and connections immediately after
disconnection to prevent contamination. Remove all covers or
plugs prior to connection.
NOTE
Perform steps 1 and 2 for right side. Perform steps 3 through 6 for
left side.
1.
Disconnect hose (1) from coupling (5).
2.
Slide yoke (2) and locating pins (3) out from caliper (4).
3.
Disconnect hose (1) from coupling (5).
4.
Remove two capscrews (8) from rotor (7).
5.
Remove rotor (7) from caliper (4) and adapter (6).
6.
Using crowfoot, remove two capscrews (10), washers (11), yoke (2), and caliper (4) from adapter (6).
NOTE
For replacement of rear dual service/parking brake caliper, refer
to para. 7-15.
